How To Use Wire Buckles For Poly Strapping

Why A Buckle?

If you are new to the pallet strapping world, you might be wondering why a buckle is needed in the first place. Basically, the buckle is going to be used to bring together the two ends of your strap and to maintain tension in the line. Without tension, your strapping will be pretty much useless. The buckle is where that tension will be held throughout the shipping process. Note, however, that this is not a method that is typically used in high-volume settings, as it isn't as fast as some other options, but it is great for those with low-volume needs.

Using The Wire Buckle

The step-by-step directions below should help you use a wire buckle with your poly strapping successfully.

• Fold one end of the strapping away from you to form a small loop. Slip the strapping through the center of the buckle and slide the loop over the open end of the wire on the far side.
• Take the strap down and away from you, running it under the far side of the buckle. From there, you will run the strapping around the package or pallet and back up to meet the buckle once again.
• With the open end of the strap, again make a loop – this time by folding toward you.
• Pull that new loop up through the strap and slide it on the open tine on the near side of the buckle.
• To tension the strap by hand, simply pull on the end of the strap. Alternatively, when more tension is required, you can use a tensioner tool.

Give Us a Call Now